5. Switch on the lights. Make sure the HIGH beam is on. DO NOT USE LOW BEAM. CAUTION 6. Observe each headlight beam aim. Proper aim is when the most intense beam is centered on the vertical mark 5 cm (2 in.) below the horizontal mark on the aiming surface. Always replace a blown fuse with a fuse of the same type and rating. If the new fuse blows after a short period of use, consult an authorized Arctic Cat dealer immediately. Electrical Output Terminals Two output terminals for electrical acces- sories are located on the front and rear wiring harnesses. Two accessory plugs are located on the dash board. 7.
Loosen the headlight adjustment screw; then adjust the headlight up or down as required. Tighten the head- light adjustment screw. NOTE: The rear output terminal is located beneath the center console near the right-side of the throttle body. The front output terminal is located beneath the dash board in front of the left-side accessory plug. PR875A Fuses The fuses are located in a power distribu- tion module under the dash below the headlight switch. If there is any type of electrical system failure, always check the fuses first. PR049A CAUTION Always use electrical accessories less than 180W.
Storage Compartment/ Tools A basic tool kit (located in the under hood storage) is provided with this vehicle. Maintain the tool kit with the vehicle at all times. PR895 NOTE: To remove the fuse, com- press the locking tabs on either side of the fuse cover and lift out. This vehicle has a storage compartment within the dashboard and a storage com- partment beneath the hood. To access the compartment located under the hood, release the two hold-down straps at the rear of the hood and tilt the hood forward. The HDX also has side storage compart- ments under each seat. 3411-968 52