Cab Radio - Section 70 OM7004 Page 70-4 In order to use the satellite radio function on your radio, a subscription must be ordered from a pro- vider. There are two providers in the U.S. currently, XM and Sirius Satellite Radio. When a subscription is ordered, an additional receiver and antenna will need to be obtained from your provider. SATELLITE RADIO Operating Satellite Radio 1. Use the BAND button to select the proper satel- lite radio band. (XM1, XM2, SR1, SR2) 2. Use the TUNE and SEEK buttons to navi- gate through the channels. To activate the external satellite receiver, you must supply the provider with your Electronic Serial Num- ber (ESN).
To find the ESN, first install the satellite receiver per instructions from the your provider. Next, follow the instructions below. Program Type Search (PTY) XM and Sirius both allow you to search by music type. Program Type Search (PTY) allows you to per- form a music search by type. Perform the following steps in order to do a PTY search. XM Satellite Radio: 1. Turn both the radio and the satellite receiver on. Press the BAND button on the radio and select either XM1 or XM2. 2. Tune your satellite receiver to channel 0 to see the ESN display. 1. Press SCAN and push-button 1 at the same time. PTY will appear on the display. 2.
Continue to press push-button 1 until the desired genre of programming is displayed. Record the ESN. The display will return to the default setting after 5 seconds. 3. Once the desired genre has been selected, Sirius Satellite Radio: press the TUNE and SEEK buttons to scroll through the different channels in that genre. Station names will appear on the display as your scroll. 1. Turn the radio on and with the display showing the clock, press and hold the DSPL/TM SET button until the hours segment is flashing. You may also scan through the channels using the scan feature. Press the SCAN button to begin scanning the channels. Press the SCAN button again to stop at the desired channel. 2.
Press the BAND button and the ESN will be dis- played. Record the ESN. The display will return to the default setting after 5 seconds. NOTE: Only one satellite receiver can be installed and connected to your receiver at one time. NOTE: Obstructions in the satellite signal may impair your satellite radio reception. Contact your provider for satellite radio reception problems.