MAINTENANCE 24.8.2 CLEAN TRANSMISSION CASE BREATHER Remove all mud and dirt from around the breather, then remove the breather and put it into a cleaning fluid to clean. Take care not to let any dust or dirt get into the transmission case through the port while the breather is removed. 24.8.3 LUBRICATE WARNING Set the work equipment in a stable condition, then turn OFF the machine and apply the lock for the work equipment control levers. Apply the parking brake, and lock the front and rear frames with the safety bar and pin. Use a grease pump to pump in grease through the grease fittings marked by the arrows. After greasing, wipe off any old grease that was pushed out. 1.
Center hinge pin (2 places) 2. Front drive shaft (2 places) 3-58 WA320-3MC