OPERATION CHECK ELECTRICAL WIRING WARNING If fuses are frequently blown or if there are traces of a short circuit in the wiring, locate the cause and carry out repair. Accumulation of flammable material (dead leaves, twigs, grass, etc.) around the battery may cause fire, so always remove such material. Check for damaged fuses and any sign of disconnection or short circuit in the wiring. Check also for loose parts. Check the following points carefully. Battery Starting motor Alternator During walk-around checks or checks before starting, always look for and remove any accumulation of flammable material fro m around the battery.
Contact your distributor for investigation and correction of the cause. DRAIN THE WATER FROM THE FUEL-WATER SEPARATOR With the engine shut-off, open the drain valve (1). Turn the valve counterclockwise approximately 1-1/2 to 2 turns until draining occurs. Drain the filter sump of water until clear fuel is visible. Do not over tighten the valve. Over tightening can damage the threads. Turn the valve clockwise approximately 1-1/2 to 2 turns to close the drain valve. Even if a filter/water separator is installed be sure to check the fuel tank to remove water and sediment in the fuel. 2-40 WA320-3MC