www.changlin.com.cn 10mm (PES.A, PES. MW), (PES. P), Part No. 3823276 Injectors Pulls Remove the injectors. Part No.3822510, Injector Bore Brush Clean the injector nozzle bore. Lubricate the sealing surface of the injector sleeve with an anti-seize compound. Assemble the injector, injector sleeve, a new copper sealing washer and the hold down clamp. Use only one washer. Service Tip: A light coat of clean 15W40 engine oil between the washer and injector can help to keep the washer from falling during installation. Install the injector, injector sleeve, copper sealing washer and hold down clamp into the injector bore. The injector fuel return connection must be toward the valve cover.
10mm (PES. A, PES. MW), (PES. P) Install the injector hold down capscrew. Torque Value: 24N.m [18ft-lb] 107 / 149 pages