Maintenance - Section 4 OM4015.1 Page 4-4 Lubrication and Service 10 HOUR (SHIFT) LUBRICATION AND MAINTENANCE CHECKS (continued) 10. AIR CLEANERS (continued)- See Section "C" of the service manual for servicing air cleaner elements. Empty air cleaner dust caps. After service, push the reset button on face of gauge (if equipped) to allow the needle to return to zero. 11. WHEELS AND TIRES - a. Inspect tires for proper inflation and wear. b. Inspect for debris embedded in tread or cuts.
After each wheel mounting operation, recheck wheel mounting capscrew tightness after approxi- mately five hours of operation, again at the end of the shift, and then periodically until all capscrews hold at the prescribed 450 ft.lbs. (610 N.m) torque. This requirement is prescribed for both front and rear wheels. 12. BODY UP SWITCH (NOT SHOWN) - Clean sensing area of any dirt accumulation. 13. FUEL TANK - Fill as required. 14. HOIST LIMIT SWITCH (NOT SHOWN) - Clean sensing area of any dirt accumulation. 15. CAB AIR FILTER (NOT SHOWN) - Under normal operating conditions, clean every 250 hours. In extremely dusty conditions, service as frequently as required.
Clean filter element with mild soap and water, rinse completely clean and air dry with maximum of 40 psi (275 kPa). Reinstall filter. COMMENTS √’d INITIALS