3.3.7. Camshaft z Coat the cam bush of cylinder block and z Assemble the cam bush and camshaft camshaft with engine oil. for them not to be damaged. z Assemble the crankshaft gear and the camshaft gear making sure that the gear 1 1 1 marks on both gears are aligned together as right figure. EFM2063I 3.3.8. Flywheel housing z Coat the thrust washer fixing bolt with an adhesive and tighten it with specified torque. EFM2065I z Coat the oil seal with lubricating oil and assemble it carefully not to be deviated or damaged by means of special tool. (Mandrel for assembling). z Attach the gasket on the surface of cylinder block where the flywheel housing is to be installed.
(In order to prevent the gasket slip down, coat a grease on the cylinder block surface.) EA6M2010 z Temporarily assemble 2ea of guide bolts for installing the flywheel housing to the cylinder block. z After fitting the flywheel housing holes to the guide pins and engage temporarily 2 ~ 3 threads of fixing bolts, and according to the tightening order (zigzag method) tighten them in the specified torque. Engine Reassembly - 84 - Torque 4 kg⋅m Torque 4 kg⋅m