3.3.11. Oil cooler z Attach a gasket on the surface in the oil cooler housing where the oil cooler is installed. z Tighten the oil cooler with fixing bolts. z Install the oil cooler assembly by tightening the fixing bolts in the zigzag order. EFM2067I 3.3.12. Starting motor z Install stud bolts at the bolt holes on the flywheel housing for installing the starter. z Insert the starter into the flywheel housing and tighten the fixing bolts. EC8OM010 3.3.13. Piston z Line up the piston assembly in the order of cylinder number and fit the 120 O bearings to the connecting rods and 2nd ring gap Top ring gap bearing caps.
However, take care not to Piston pin swap between the connecting rods and z Coat the pistons and connecting rod bearing caps. 120 O 120 O bearings sufficiently with clean engine Oil ring gap Piston oil. EFM2069I z By means of a special tool, insert the piston rings and adjust the angles between the ring gaps at 120 ° as right figure. z Push in the piston with hands or wooden bar into cylinder. (Be careful for piston and rings not to be damaged.) Engine Reassembly - 86 -