3.3.20. Rocker arm z Coat the push rod with engine oil and z Make a position the rocker arm put it into the push rod hole. assembly on the cylinder head and tighten the fixing bolts to the specified tightening torque. z Adjust the valve clearance. EFM2091I Regarding the adjustment, refer to the regular maintenance part. 3.3.21. Checking and adjusting valve clearance z After removing the head cover loosen screws using a spanner and push the the lock nuts of rocker arm adjusting filler gauge of specified value between rocker arm and valve stem.
z Tighten the adjusting screw using a driver until the inserted feeler gauge can be taken a slight resistance between the valve stem and the rocker EBO4007S 2 1 3 arm. Then tighten the lock nut simultaneously on not moving the z After checking the clearance once more adjusting screw. if necessary re-adjust it. 3.3.22. Cylinder head cover z Attach the new gasket on the surface of cylinder head where the cover is to be installed. z Assemble the cylinder head cover by tightening the fixing bolts. z Insert the oil filler cap. EFM2020I Engine Reassembly - 91 - Torque 6.5 kg⋅m