z How to adjust injection timing If upper pre-checked injection timing degree is wrong, follow as below. (1) Loosen the fixing bolts(M8) of the injection pump driving gear in order to adjust the injection timing slightly. (2) Turn the crank pulley clockwise until V-groove of the flywheel housing sight hole is aligned with the injection timing degree of the engine. (3) Coincide the mark on pointer provided in injection pump with the matching mark (FB) on the flange surface of the drive gear by turning the flange in the oblong holes of the drive gear. (4) Tighten the bolt (M8) to specified torque. (2.2 kg m ) not to move the drive gear.
(5) After confirmation that fastening bolts are completely tightened check the start point (injection timing degree) of fuel delivery setting once more if not right repeat it again as same as upper way. 3.3.25. Flywheel housing cover z Attach the gasket to the flywheel housing cover. z Install the flywheel housing cover and tighten the fixing bolts by zigzag method. EFM2072I 3.3.26. Oil filter z Install the oil filter cartridge. EFM2079I Engine Reassembly - 94 - EBO4016I