15. Install remaining bolt to camshaft gear cover and torque to 136 N·m (100 lb·ft). See Figure 17. 1. Bolt 2. Camshaft Gear Cover Figure 17 Camshaft Bolt 16. Ensure timing of the gear has been verified. Refer to Step 6. 17. Remove timing pin from crankshaft and alignment tool from gearcase cover. 18. Check camshaft gear lash and adjust if necessary. Refer to section 1.21. ADDITIONAL SERVICE INFORMATION Additional service information is available in the Detroit Diesel Series 60 Service Manual, 6SE483. The next revision to this manual will include the revised information. As a convenience to holders of the Series 60 Service Manual , information in service manual format is attached.
The page(s) may be inserted into the manual.