OPTIONS, ATTACHMENTS 31.6 PRINTING DATA Two types of data can be printed: SUBTOTAL and TOTAL. The data can only be printed while the amount loaded in the bucket is being displayed. 31.6.1 PRINTING SUBTOTAL Press the SUBTOTAL switch to print the data. The switch is located on the load meter and the work equipment control lever. The display is as follows: SUBTOTAL mode Date of print out Time of print out Amount of each load Total load After the SUBTOTAL is printed, the SUBTOTAL display becomes 0.00 (0.0) tons. If no new measurement is performed, the same data can be printed as many times as desired.
REMAIN mode Date of print out Time of print out Target production amount Amount of each load Total load 31.6.2 PRINTING TOTAL Pressing the TOTAL switch erases the data in the load meter memory. All of the measured loads are printed as a total. The TOTAL is the accumulated total, regardless of the data printed for the SUBTOTAL. The loads are added until the total reaches a maximum of 16, 772.15 tons. However, if printing just the TOTAL amount loaded each day is needed, erase the memory before starting work. To erase the data, See 31.7 DELETING DATA FROM STORAGE DEVICE on page 5-97. WA450-3MC 5-24