Replica 1 TE Users Manual Chapter 4: Assembling the replica 1 TE kit If you have experience with soldering circuit boards, then not only will you enjoy the replica 1 kit, but you will also have the pride in assembling it yourself while saving money. If you have never built a circuit board kit, please start with something a little simpler before attempting to build the replica 1. This chapter is only designed as a brief guide to help you assemble your replica 1. Kit contents: All kits have been carefully assembled to insure that no parts are missing; however, you should check the inventory to make sure you have everything. If you find anything missing, please contact Briel Computers. IC’s:
QTY MODEL ID # of Pins 1 6502 U1 40 1 6821 U2 40 1 62256 U4 28 1 27C64 U3 28 1 P8X32A-D40 U8 40 1 74LS00 U6 14 1 74LS04 U7 14 1 74LS138 U5 16 1 74LS245 U10 20 1 MAX232 U11 16 1 24LC256 U9 8 1 7805 V1 3 1 3940 (3.3V) V2 3 Sockets: QTY # of Pins 3 40 pin 2 28 pin (.6 wide) 1 20 pin 2 16 pin 1 16 pin duel swipe 2 14 pin 1 8 pin Crystals and Oscillators: QTY Type Size Speed 1 Crystal HC49/U 5MHz (X2) 1 Oscillator Full Can 1MHz © Briel Computers 2007 page 13