GETTING TO KNOW YOUR VEHICLE 19 H OW T O U SE R EMOTE S TART All of the following conditions must be met before the engine will remote start: WARNING! Push and release the Remote Start button on the key fob twice within five seconds. The vehicle doors will lock, the parking lights will flash, and the horn will chirp twice (if programmed). Then, the engine will start, and the vehicle will remain in the Remote Start mode for a 15 minute cycle. Pushing the Remote Start button a third time shuts the engine off. Gear selector in PARK Do not start or run an engine in a closed garage or confined area. Exhaust gas contains Carbon Monoxide (CO) which is odorless and colorless.
Carbon Monoxide is poisonous and can cause serious injury or death when inhaled. Doors closed Hood closed Liftgate closed 2 Hazard switch off Brake switch inactive (brake pedal not pressed) Keep key fobs away from children. Operation of the Remote Start system, windows, door locks or other controls could cause serious injury or death. To drive the vehicle, push the unlock button, and with a valid Keyless Enter ‘n Go™ key fob in the vehicle, place the ignition in the ON/RUN position. Battery at an acceptable charge level PANIC button not pushed System not disabled from previous remote start event NOTE: With Remote Start, the engine will only run for 15 minutes.
Vehicle Security system indicator flashing T O E XIT R EMOTE S TART M ODE Remote Start can only be used twice. Ignition in OFF position To drive the vehicle after starting the Remote Start system, either push and release the unlock button on the key fob to unlock the doors, or unlock the vehicle using Keyless Enter ‘n Go™ — Passive Entry via the door handles, and disarm the Vehicle Security system (if equipped). Then, prior to the end of the 15 minute cycle, push and release the START/STOP ignition button. If an engine fault is present or fuel level is low, the vehicle will start and then shut down in 10 seconds.
Fuel level meets minimum requirement Vehicle Security system is not signaling an intrusion The park lamps will turn on and remain on during Remote Start mode. Malfunction Indicator Light (MIL) is not illuminated For security, power window operation is disabled when the vehicle is in the Remote Start mode. The ignition must be placed in the ON/RUN posi- tion before the Remote Start sequence can be repeated for a third cycle.