SEN01344-00 00 Index and foreword q 125 – 170, 12V140 engine 4) While pressing lock (E) of the connector, pullout connector (5) in the direction of the arrow. 4. Turn-housing type (Round green connector) q 140 engine Example) Intake air pressure sensor in intake mani- fold (CANNON-04): PIM etc. Example) Fuel pressure in common rail: PFUEL etc. ( AMP-3 ) 1) Disconnect connector (6) according to the following procedure. 1] Turn housing (H1) in the direction of the arrow. a When connector is unlocked, housing (H1) becomes heavy to turn. 2] Pull out housing (H1) in the direction of the arrow. a Housing (H1) is left on the wiring har- ness side.
Example) Injection pressure control valve of fuel supply pump: PCV ( SUMITOMO-2 ) 2) Connect the connector according to the following procedure. 1] Insert the connector to the end, while setting its groove. 2] Turn housing (H1) in the direction of the arrow until it “clicks”. Example) Speed sensor of fuel supply pump: G ( SUMITOMO-3 ) a Pull the connector straight up. 22 BR380JG-1E0