3 1 2 34 2 561 R28340160 Integral ABS: Removing and install- ing brake lines • Check that square-section rings are correctly seated. • Install new spring clips. • Slip the protective caps up the brake lines. • Clip in brake lines. • Check that spring clips are correctly positioned (arrows). • Seat the protective caps on the connectors. • Fill and bleed the brake system ( a 34.19). • Drain the brake system ( a 34.16). • Push protective caps (1) up. • Remove spring clips (2). • Remove brake lines. • Installation is the reverse of the removal proce- dure: pay particular attention to the following. d Warning: Always fit new spring clips each time the plugs are disconnected.
Ensure correct positioning. X Tightening torque: Brake hose and brake line............................ 18 Nm Bleed screws in front brake calipers............... 7 Nm Bleed screw in rear brake caliper ................... 5 Nm e Attention: Fit new sealing rings for brake line. Secure brake line to master cylinder so that it can- not become kinked or abraded when the handlebars are turned. L Note: Always replace the seals (square-section rings) be- tween the brake lines and the pressure modulator when you replace the brake lines. • Carefully remove square-section rings (3) using disassembly tool, BMW No. 34 2 561 . • Install square-section rings with brake lines. 34.31