5. Guide the thread through the small hole in the side of the bob- bin from the inside. Align the groove in the bobbin with the spring on the shaft and place the bobbin on the bobbin winder shaft. While holding the thread end, push the bobbin winder shaft to the right. 2 1 1 1 Spring on the shaft 2 Groove of the bobbin 6. Set the speed to minimum. 2 7. While holding the thread end, press the “START/STOP” but- ton. Wind the thread a few times around the bobbin and press the “START/STOP” button again. Trim the excess thread from the top of the bobbin after the machine stops. Press the "START/STOP" button. The bobbin will stop spin- 10. When the bobbin stops spinning, press the "START/STOP" 11.
Push the bobbin shaft to the left. Remove the bobbin. 18 8 9 1 0. When the b button to st 2 1