Chapter 2: Installation Use JPUSB jumpers to enable the function of "System Wake-Up via USB devices", which al- lows you to "wake-up" the system by pressing a key on the USB keyboard or by clicking the USB mouse of your system. The JPUSB jumpers are used together with the USB Wake-Up function in the BIOS. Enable both the jumpers and the BIOS setting to allow the system to "wake-up via USB Devices". See the table on the right for jumper settings and jumper connections. USB Wake-Up Note 1: JPUSB1 is for Back Panel USB ports:0/1/2/3/4/5, and JPUSB2 is for Front Panel USB ports:6/7/8/9/10.) Note 2: The default jumper setting for the USB ports is "Disabled".
However, when the "USB Wake-Up" function is enabled in the BIOS and the desired USB ports are enabled via the JPUSB jumper, please be sure to remove all USB devices from the USB ports whose USB jumpers are set to "Disabled" before the system goes into the standby mode. A. JPUSB1 B.
JPUSB2 COM1 VGA J12 CD1 Front Audio CD-IN JPAC J9 PCI1 Buzzer Slot4 PCI-33MHz COM4 USB 10 JWOL J3 IDE#1 ITE 8213 COM3 J47 J45 J44 FP USB 6/7 FP USB 8/9 JPUSB2 JWD JLED FAN2 B SPEAKER SPKR J15 J14 2-25 JPUSB2 (Front Panel USB Wake-up) Pin# Definition 1-2 Enabled 2-3 Disabled (*default) JPUSB1 (Back Panel USB Wake-up) Pin# Definition 1-2 Enabled (*default) 2-3 Disabled J41 CPU Fan KB/MOUSE FAN1 4-Pin PWR 28 LGA 775 CPU JPT1 I/O 2 W83627DHG S I/O 1 W83627DHG S 1 PWR COM2 ATX DIMM1A DIMM2A DIMM1B DIMM2B 24-pin GS1 J JF FS SB B1 2 J4 2U/S3/ B4 /5 J43 A Intel Q35 JPUSB1 USB 0,1 LAN 1 J11 JFSB3 Audio Fan3 46 LAN CTRL Slot7 PCI-E x16 PCI3 JWOR Slot6 PCI-33MHz JJII22CC S21 lot5 PCI-E x4 Battery JBT1 JPL1 Intel ICH9DO III --- SSS AAA TTT AAA 210 LE1J JL F C2SBM-Q PCI2 PCI1 JS3JS2 JS1 I-SATA3 JS4 Audio CTRL JP2 IDE CTRL 0 1 1 CTRL FP