Bottom assemblies ECU pan 1 Remove the following assemblies: Toner cartridge, media tray, and cable pod. See “Toner cartridge” on page 15 through “Cable pod” on page 17. Left side, back, and right side covers. See “Left side cover” on page 18 through “Right side cover” on page 24. 2 Unplug the three spade connectors (callout 1). 3 Disconnect the motor cable connector (callout 2). 4 Unplug the fuser cable connector (callout 3) by pressing and releasing the clip on the back of the connector. 5 Unplug the remaining four wire harness connectors (callout 4) from the ECU. 2 1 2 2 3 2 4 Figure 45. Disconnect the ECU wire harnesses 56 Chapter 2 - Removal and replacement Q1342-90910