Leading edge glass calibration Note Before beginning the leading edge glass calibration, perform the tray registration calibration on the print engine. To perform the tray registration calibration, touch MENU , then touch CONFIGURE DEVICE , then touch PRINT QUALITY , then touch SET REGISTRATION , then touch SOURCE , and then touch PRINT TEST PAGE . Follow the instructions on the printed registration page to complete the registration setting. Note Make sure you perform the leading edge glass calibration for all of the trays. 1 Download the HP LaserJet 9000mfp calibration target and the HP LaserJet 9000mfp calibration values chart.
2 On the MFP to be calibrated, print the calibration target on ledger or A3 paper. See figure 196. 3 Print two copies of the calibration values chart on ledger or A3 paper. 4 Load the calibration target face down on the glass with the left edge of the calibration target toward the back of the glass. 5 Copy the calibration target. 6 Align the top edge of the copied calibration target to the top edge of the original calibration target. Note Make sure you align the paper edges and not the lines. 7 On the calibration target, compare the line on the left side of the original to the line on the left side of the copy. 8 Determine whether the copied page needs to be shifted up or down.
If the copied page needs to be shifted, determine the required distance in millimeters. 9 Using the two HP LaserJet 9000mfp calibration values charts, determine the value for the leading edge glass that will be entered into the service menu. See figure 199. 218 Chapter 7 Troubleshooting C8523-90921