Chapter 5: Advanced Serverboard Setup 5-5 Installing the Processor and Heatsink ! When handling the processor package, avoid placing direct pressure on the label area of the fan. Notes: Always connect the power cord last and always remove it before adding, 1. removing or changing any hardware components. Make sure that you install the processor into the CPU socket before you install the CPU heatsink. AMD's boxed processor package contains the CPU fan and heatsink 2. assembly. If you buy a CPU separately, make sure that you use an AMD- certifi ed multi-directional heatsink and fan only. Make sure to install the serverboard into the chassis before you install the 3.
CPU heatsink and heatsink fan. When purchasing an AMD Opteron 2000 series processor or when receiving 4. a serverboard without an Opteron 2000 processor pre-installed, make sure that the plastic CPU cap is in place and none of the socket pins are bent; otherwise, contact your retailer immediately. Refer to the Supermicro web site for updates on CPU support. 5. Installing an Opteron 2000 Processor Note : The photos on this page and succeeding pages are for illustration purposes only. They do not necessarily refl ect the exact product(s) described in this manual. Begin by removing the cover plate 1. that protects the CPU. Lift the lever on the CPU socket until it points straight up.
With the lever raised, lift open the silver CPU retention plate. Use your thumb and your index 2. fi nger to hold the CPU. Locate and align pin 1 of the CPU socket with pin 1 of the CPU. Both are marked with a triangle. Align pin 1 of the CPU with pin 1 of the socket. 5-5