cisco — Configuring the Source Interface and DSCP Marking on RADIUS Server Group

Configuring the Source Interface and DSCP Marking on RADIUS Server Group Follow these steps to configure the source interface and DSCP marking for authentication and accounting on radius server groups: Procedure Configuring RADIUS Configuring the Source Interface and DSCP Marking on RADIUS Server Group Command or Action Purpose Step 4 address { ipv4 | ipv6 } ip address [auth-port auth port number acct-port _ _ acct port number] _ _ Example: Device(config-radius-server)# address ipv4 10.1.1.1 auth-port 1645 acct-port 1646 (Optional) Specifies the IP address of the RADIUS server. • auth-port configures the port value for radius authentication server. The default value is 1812.

• acct-port configures the port value for radius accounting server. The default value is 1813. Step 5 dscp {acct dscp acct value|auth _ _ dscp auth value} _ _ Example: Device(config-radius-server)# dscp auth 10 acct 20 Configures DSCP marking for authentication and accounting on the radius server. • acct configures radius DSCP marking value for accounting. The valid range is from 1 to 63. The default value is 0. • auth configures radius DSCP marking value for authentication. The valid range is from 1 to 63. The default value is 0. Step 6 key string Example:

Device(config-radius-server)# key rad123 Specifies the shared secret text string used between the device and the vendor-proprietary RADIUS server. The device and the RADIUS server use this text string to encrypt passwords and exchange responses. Step 7 end Example: Device(config-radius-server)# end Exits RADIUS server mode and enters privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device> enable Enables privileged EXEC mode. Step 2 configure terminal Example: Device# configure terminal Enters global configuration mode. Configuring RADIUS 35