M.H.C.V. Product CONNECTIONS FOR BODY BUILDERS To simplify Body Builders activities (PTO control, 2 nd speed limiter, ..), dedicated electrical provisions are included as standard for all EuroCargo Euro 4 models. Electrical Connector No.1 : A 21 pin connector (Brown colored, male) is located in the cab under the fuse box (passenger side, near ABS/ECAS central unit) and provides the following signals:
PIN 1 Engine start, for activation short cut to PIN 17 PIN 2 Engine stop, for activation short cut to PIN 17 PIN 3 Brake signal (0 V when brake pedal is not pressed +24V when brake pedal is pressed) PIN 4 Vehicle standstill signal (0 V when vehicle moving +24V when vehicle standstill) PIN 5 Handbrake signal (0 V when parking brake is not engaged +24V when parking brake is engaged) PIN 6 Not connected PIN 7 Vehicle Speed (pulse signal) PIN 8 Engine status signal (0 V when engine standstill +24V when engine running) PIN 9 Gearbox status signal (0 V when neutral not engaged + 24V when neutral engaged) PIN 10 Gearbox reverse gear signal (0 V when reverse engaged +24V when reverse not engaged) PIN 11 K15 Ignition ON, after fuse (24V-5A) PIN 12 Cruise Control SET+, for activation short cut pin 17 PIN 13 Cruise Control SET-, for activation short cut pin 17 PIN 14 Cruise Control OFF, for OFF activation short cut pin 17 PIN 15 Cruise Control RESUME, for activation short cut pin 17 PIN 16 Cruise Control activation by driver or Body Builders, controlled by BB short cut pin 17 21 Pin Connector Commercial Documentation - Eurocargo Euro 4 Page No.
D.23