Chapter3 Handling 239 Setting menu Settings Default Lock Setting General Settings Printer Settings Media Settings Print Options Print Mode Cut Stop at Cut - ✔ - Position Stop at Cut Position - ✔ - Stop at Peel-Off Position - ✔ - Stop at Print End Position - ✔ - Cut Position -10.8 to +10.8[mm] / 0[mm]/ - ✔ - -0.425 to +0.425[inch] 0[inch] Reprint Enable Enable - ✔ - Disable - ✔ - Media Hold Pressure Auto Auto - ✔ - Manual (1 to 10) - ✔ - Cancel Action Job ONLY Job ONLY - ✔ - Job/RAM Drive - ✔ - Actions when Replacing Media Feed with Cut Feed without - ✔ - Cut Feed without Cut ✔ Not Feed - ✔ - Calibration - ✔ - Short Calibration - ✔ - Check Media Size - ✔ - Actions on Power On Feed with Cut Not Feed - ✔ - Feed without Cut Not Feed - ✔ - Calibration - ✔ - Short Calibration - ✔ - Check Media Size - ✔ - Print Mode Cut Stop at Cut - ✔ - Position Stop at Cut Position - ✔ - Stop at Peel-Off Position - ✔ - Stop at Print End Position - ✔ - Cut Stop at Cut Position - ✔ - Stop at Cut Position - ✔ - Stop at Peel-Off Position - ✔ - Stop at Print End Position - ✔ - Cut Position -10.8 to +10.8[mm] / -0.425 to +0.425[inch] 0[mm]/ 0[inch] - ✔ - Reprint Enable Enable - ✔ - Disable - ✔ - Enable Enable - ✔ - Disable - ✔ - Media Hold Pressure Auto Auto - ✔ - Manual (1 to 10) - ✔ - Auto Auto - ✔ - Manual (1 to 10) - ✔ - Cancel Action Job ONLY Job ONLY - ✔ - Job/RAM Drive - ✔ - Job ONLY Job ONLY - ✔ - Job/RAM Drive - ✔ - Actions when Replacing Media Feed with Cut Feed without - ✔ - Cut Feed without Cut ✔ Not Feed - ✔ - Calibration - ✔ - Short Calibration - ✔ - Check Media Size - ✔ - Feed with Cut Feed without Cut - ✔ - Feed without Cut ✔ Not Feed - ✔ - Calibration - ✔ - Short Calibration - ✔ - Check Media Size - ✔ - Actions on Power On Feed with Cut Not Feed - ✔ - Feed without Cut Not Feed - ✔ - Calibration - ✔ - Short Calibration - ✔ - Check Media Size - ✔ - Feed with Cut Not Feed - ✔ - Feed without Cut Not Feed - ✔ - Calibration - ✔ - Short Calibration - ✔ - Check Media Size - ✔ -