Chapter3 Handling For the Auto Cutter Model • Cut (after printing last label) • Cut (at specified label) • Cut (after last page of collate page) • Do not cut (stop at cut position) (initial setting) • Do not cut (stop at peel position) • Do not cut (stop at the print end position) For the Peeler Model • Manual apply (Initial setting) • Auto apply • Rewind c IMPORTANT • If you have set to [Cut (after last page of collate page)] and if the printer stops due to a paper jam or other reason while the auto cutter is operating after printing, it is impossible to resume printing.
• Cautions for when [Label length] is set to a value less than 15.0 mm (0.59 inches) • Auto cutting is not possible because a paper jam may occur. • You can select all three [Cut] options below in [Settings For Paper Handling After Print]. - Cut (after printing last label) - Cut (at specified label) - Cut (after last page of collate page) • If you have selected [Cut (at specified label)] for [Settings For Paper Handling After Print] and selected the [Collate] check box on the [Options] tab, specify the number of pages per copy in [Cut Interval]. If you have not selected the check box, we recommend specifying the number of copies in [Cut Interval].
• When [Settings For Paper Handling After Print] - [Cut (at specified label)] - [Cut Interval] is set to "1", the driver automatically changes [Cut Interval] to "2" to reach or exceed the minimum label length that can be cut (15.0 mm (0.59 inches)). Also, to ensure that the label length does not become less than the minimum label length that can be cut (15.0 mm (0.59 inches)), "1" can no longer be set for [Cut Interval]. 83 12 Settings For Paper Handling After Print