Chapter 3 Commands Setting Commands This section describes the commands for setting the external I/O. End print signal (output) mode settings [Format] ^S(CNA,B,c [Parameter] c [Function] Configure the mode settings for the end print signal. 3 [Initial value] 0 [Signal timing] 24 Description Definition range c = Mode setting D/E/N/0/1/2/3/4 Value for parameter c Description D/0 Turn the end print signal OFF. (End print signal not output) 1 Set the end print signal (pin 18) as follows: Normal: High, When feeding paper: Low. E/2 Set the end print signal (pin 18) as follows: Normal: Low, When feeding paper: High. 3 Set the end print signal (pin 18) as follows: Normal:
High, When continuous printing ends and the printer stops at the predetermined position: Low for 20 msec. N/4 Set the end print signal (pin 18) as follows: Normal: Low, When continuous printing ends and the printer stops at the predetermined position: High for 20 msec. Signal Printer status Signal status Sent label format Processed label format Standby for start signal Print label Ready to print next label Data preparation complete Preparing Preparation complete Start print Do not start Start End print Not finished Finished