Chapter 3 Commands Mode setting for clogged nozzle check signal (input) [Format] ^S(CNI,D,c [Parameter] c [Function] Configure the mode setting for the clogged nozzle check signal. [Initial value] 0 [Examples of command transmissions] 3 Set the clogged nozzle signal to "Check the nozzles when a Low signal is input for 30 msec or longer". The ^JUS command must be used to save the settings to the non-volatile memory in the printer. An example of the command transmission is shown below. It is sent via USB or Ethernet from the computer. ^XA ^S(CNI,D,1 ^JUS ^XZ 37 Description Definition range c = Mode setting 0/1 Value for parameter c Description 0 Ignore the clogged nozzle check signal (pin 14).
1 Set the clogged nozzle check signal (pin 14) to the following mode: Check the nozzles when a Low signal is input for 30 msec or longer.