Chapter3 Handling Editing the layout When label (page) length is long, length of printed image may be shorter than the specified length depending on paper used. It causes an extra margin on the bottom of the label (page) (bottom means rear end in the paper feed direction). If you want to reduce the margin, try the following method. Step 1: Examine print results on labels. Step 2: Add the length of the extra margin to [Length] in Layout settings. 190 Item Description Media layout name Allows you to set a name for a new paper layout settings. Enter a name to set. Defined media layout If one or more sets of user-defined paper layout settings already exist, they are listed here.
Media form (detection) Allows you to select a media form. Layout Information The layout information that can be set changes depending on the [Media form (detection)] setting. Before making this setting, set Media form (detection). • When using die-cut label, full-page label, or continuous paper Set the width, length, left and right gaps, and gap between labels. • When using tag Set the hole type, width, length, left gap, right gap, gap between labels, and distance between hole and paper edge.