Appendix Fanfold Continuous Paper (Black Mark) Paper feed direction Black mark center position Center of Paper Perforation Cut Uncut 2.0 mm {0.08 in.} or more Black mark Black mark length Cut position Black mark width • Auto cutting on the perforation lines will generate scraps of paper that may cause problems. Also, auto cutting ahead of the perforation line may cause problems when feeding paper. Therefore, perform auto cutting when paper is fed at least 0.5 to 1 mm {0.02 to 0.04 in.} away from the perforation line.
• Since the black mark detector is not located at the center position of the paper width, if there are black marks on both sides of the paper, black marks will be detected no matter which side of the paper you print from. 373 aper width Black mark interval Width Item Specifications Paper Type Plain paper, Matte paper, Glossy paper Paper width 50 to 112 mm {1.97 to 4.41 in.} Black mark position See the above figure.
At least 2.0 mm {0.08 in.} away from the perforation Black mark width 19 mm {0.75 in.} or more Black mark length 4 to 25.4 mm {0.16 to 1.00 in.}, with 4 mm {0.16 in.} or more of space around the mark Black mark center position 12.4 mm {0.49 in.} Black mark interval 11 to 304.8 mm {0.43 to 12.00 in.} Auto cut is not possible when the length of the paper is less than 15 mm {0.59 in.}.
Pap er thickness 0.084 to 0.131 mm {0.003 to 0.005 in.} Fold interval 152.4 to 304.8 mm {6.00 to 12.00 in.} Number of folds 750 or less Perforation form 3 to 5 mm {0.12 to 0.20 in.} of slit length with 1 mm {0.04 in.} interval * There should be no slits at both side edges of paper Holes and cutouts Paper with holes or cutouts cannot be used