Chapter 2 Setup Setting the DP-110 Connector installation screw Inch-type hexagonal lock screws are installed in the connector for serial cable connection of DP-110. If millimeter-type lock screws are needed, use the millimeter-type lock screws of the accessory. Notch (one or more lines) inch-type millimeter-type Installation screw Jumper setting Set the jumpers as follows: 2 32 JP1 JP2 Description 1-2 1-2 For connecting both the TM printer and the DP-110. (Default setting) 2-3 2-3 Set this when using a standalone connection.