Монтаж Руководство по проектированию VLT ® HVAC Drive FC 102 5.2.14 Электрический монтаж, Кабели управления 130BC548.12 230 VAC 50/60 Hz TB5 R1 Anti-condensation heater (optional) 230 VAC 50/60 Hz TB6 Contactor (optional) 91 (L1) 92 (L2) 93 (L3) PE = = = (U) 96 (V) 97 (W) 98 (PE) 99 3 Phase power input Load Share Switch Mode Power Supply 95 Motor 5 5 88 (-) 89 (+) 10 VDC 24 VDC (R+) 82 Brake resistor +10 VDC 50 (+10 V OUT) (R-) 81 + - + - 15 mA 200 mA 0 VDC - 10 VDC 0/4-20 mA 53 (A IN) A54 U-I (S202) ON=0-20 mA OFF=0-10 V A53 U-I (S201) Relay1 400 VAC, 2A 0 VDC - 10 VDC 54 (A IN) 2 1 ON 03 02 240 VAC, 2A 0/4-20 mA 55 (COM A IN) 01 12 (+24 V OUT) Relay2 06 240 VAC, 2A 13 (+24 V OUT) 400 VAC, 2A P 5-00 24 V (NPN) 0 V (PNP) 05 18 (D IN) 0 V (PNP) 24 V (NPN) 19 (D IN) 04 20 (COM D IN) (COM A OUT) 39 (A OUT) 42 0/4-20 mA Analog Output 24 V (NPN) 0 V (PNP) 27 24 V (D IN/OUT) S801/Bus Term.
OFF-ON ON=Terminated OFF=Open 1 Brake Temp (NC) 24 V 29 0 V (PNP) 24 V (NPN) (D IN/OUT) 0 V 5 V 2 S801 0 V 0 V RS-485 RS-485 (P RS-485) 68 32 (D IN) 0 V (PNP) 24 V (NPN) Interface (N RS-485) 69 33 (D IN) 24 V (NPN) 0 V (PNP) (COM RS-485) 61 (NPN) = Sink (PNP) = Source 37 (D IN) - option Рисунок 5.88 Схема межкомпонентных подключений для типоразмера D MG16C150 — Вер. 13–01–2014 157 1 2 ON 1 2 ON