Using Windows NT 4.0 Installing Windows NT 4.0 you must repartition the hard disk. The HP Notebook Windows 95/98 image uses a FAT32 partition. Windows NT 4.0 does not support FAT32. Follow the instructions below to repartition your hard disk. 1. Connect the ac adapter to the Notebook. 2. Insert the CD-ROM/DVD Drive in the Notebook. 3. Insert the bootable Recovery CD into the CD-ROM/DVD drive. 4. Reboot, press ESC twice when you see the HP Notebook logo. 5. Select the “CD-ROM/DVD Drive” as the boot device. 6. Click 2 Continue. 7. Click 2 Advanced. 8. Select your desired Hibernate Partition Size. 9. Check “Do not load operating system”. 10. Select “Hibernate partition only”. 11.
Click 1 Continue. 12. Click Ok. To install Windows NT 4.0 1. Insert the Windows NT Workstation CD into the CD-ROM drive. 2. Reboot, press ESC twice when you see the HP Notebook logo. 3. Select the “CD-ROM/DVD Drive” as the boot device. 4. At the Welcome Screen, press Enter to begin. 5. Press Enter to accept the IDE CD-ROM mass storage device. 6. If prompted that the drive contains more than 1024 cylinders, press Enter. 7. Read the Windows NT Licensing Agreement. Press Page Down until you reach the end of the document. Press F8 to agree. 8. Press Enter to accept the default hardware and software components. 9. Select the first unpartitioned space, then press C. 10.
Enter the size of the partition desired and press Enter. Corporate Evaluator’s Guide 133