— AMCP 706-286 — Engineering Design Handbook (1963)

h] Downloaded from https://www.everyspec.com -" STRUCTURES V 3-6.3. Ring Frame. if a ring frame is (T- TI)., which varies with y. The first heated uniformly, no thermal stresses arise term causes no thermal stresses and ihe in it provided it is made of a single material maximum stress cauced by the second is and is free to expand. if, however, the tern- given by Equati3n (3-44) with the stress, perature of the outer surface of the ring ex- distributed linearly across the section. The ceeds by _%T that of the inner surface, as third term, (T - T).,,, can be substituted in indicated in Figure 3-6, the thermal change Equation (3-38) in order to obtain the addi- tional thermal stress. 3-f.A.

Circular Cylindrical Shell. The thin- walled circular cylindrical shell of Figure 3-7 T, AT is uniformly heated to a temperature exceed- ing by AT the uniform temperature of the ring frame. If the wall thickness of the shell is h and the cross-sectional area of the ring frame is A, the hoop compressive stress in the shell at the location of the ring is . . = raET (3-45) and the maximum axial bending stress is A. A H c,, = 1.82rfET (3-46) I- -provided that Poisson's ratio is 0.3. The [, SECTION A-A value of the multiplying factor is r = 1/[1 + (2,'K)(Rh,-A)j (3-47) with K = 1.29.v/R-/i (3-48) - It can be seen from these equations that . the value of r is always between 0 and 1. Figure 3-6.

Ring Frame with Temperature When the area of the ring is very small, r is Varying Linearly Through Depth very small, and the small amount of con- straint provided by the ring does not give in the curvature is restrained by the conti- rise to large thermal stresses. When A is nuity of the structure. When the temperature very large, r is not much smaller than unity, increase from the initial uniform tempera- and the hoop compressive stress corresponds ture is a linear function of the depth of the to almost perfect constraint. section, but is uniferm along the circumfer- ence and at the same time the ring frame has 3.7.

THERMAL BUCKLING two axes of symmetry as shown in the figure, the axium heral bndig sres !s3-7.1. Columns. The column does not know th awhether the compressive stress in it was I,. ± (1 2)aEAT (3 44) caused by restrained thermal expansion or In the derivation of this formula the addi- by an applied load. Consequently the cus- tional assumptions were made that the cross tomary buckling formulas can be used wth section of the ring was doubly symmetric confidence as soon as the compressive ther- and that one axis of symmetry was in the mal stress is known. In particular, one may plane of the ring.

write for the critical stress of a simply sup- When the temperature vwries arbitrarily I ported column with y (through the section), but is constant r2 = i E,(L, 'p)- (3-49) around the circumference of the ring, the in- where Et is the tangent moclulus (sue Figure crease in temperature can be represented as 3-3), L is the length of the column, and P is the sum of an average increase, a linear the radius of gyration of its cross section. variation with y, and an additional term The ratio L/p is known as the slenderness ( j 48