Downloaded from https://www.everyspec.com STRESS ANALYSIS "~ .1 A..... @ ' A' Figure 3-7. Ring-Reinforced Circular Cylindriced Shelf X1 SI0 Figure 3-8. Simply Supporled Pla',e Subjected to Thermal Stresses in One Direction ratio. When the stres does not exceed the buckling taks place at the following critical elastic limit of the material at the operating value of the average st.ress: temperature, E, becomes E. 3-7.2. Simply Supported P:ates. In the case 0,0.. = - (p 2)1 (3 52) I of plates the customary buckling formulas aao n plae theid. cust buckling formuls The following e. amples will illustrate the again are valid. Thus the buckling stress of meaning of this formula:
When p = , from a simply supported rectangular plate of con- stan th ckne s i (se Fi ure -8)Equation (3-51) thp stiess at the two edges stant thickness is (see Figure 3 (y o and y = b) is 2(%,., while in the middle acin i h 3.6E(h, b)2 (.q 50) (y b 2) it is zero. Equation (3-52) yields where a is a uniform compressive stress in this case a ...... - 2a.,.. Hece the shifting acting in the x direction. of the compression toward the supported The complication arising from the thermal edges and the consequent reliel of the un- nature of the stiesser, is that the distribution supported niiddle portion increases the criti- is usuaily not uniform.
For a :igorous evalu- cal value of the average stress by a factor ation of the conditions of buckling, reference of 2. On the other hand, p = -I increases should then be made to the literature. When the compressive stress in the middle to 2 a.. the distribution can be approximated by the and decreases it along the edges; the result formula is a decrease of the critical value of the or= ao1 + p cos (2iry/b)) (3-51) average stress by a factor of 2,3. 49 VI