Downloaded from https://www.everyspec.com A DESIGN CONSIDERATIONS ) on all four sides and un.tormly .ompressed in the case, howe-r, if the bar in iuest" )n is one direction can easily be calculated for but one bar of a redundant framework, be- elastic buckling. If the plate were to i~ cause the other bars in the framework can rolled into a cylinder, the critical stress due absorb additional loads. A flat or curved two- to uniform axial compression would be dimensional element in edgew-.e compres- about 200 times higher basd on an original sion in one direction will buckle a, a rela- square plate of 12 inch sides and a thickness tively Jow load, especially if the thickness is of J.032 inch.
small. This does not correspond to the maxi- Failure by b-ickling is at times the de- mum load or failure if the unloaded sides are cisive criterion in the selection of a material supported. The material near the supports of construction and in the determination of is constrained against transverse deflection cross-section areas. As an example of how and can absorb loads beyond those corre- buckling considerations can affect the choice sponding to the bu'kling load. of a materipl, consider a fiat plate subject to edge compression in one direction. The buck- 4-6. 1319E AND ҐTMPERATURE DVENDENCE ling stress of the plate varies with the square OF MIGN CRITEIA of the thickness.
A comparison of the buck- ling stress is desired between two plates; ona Most of the mechanical deaign criteria of aluminum and one (.f steel. The plates are previotsly disussed are applabe not only to have the same length and width, and the to missiles but also to other types of flight sam,. weight. Since alurninum is about 1/,3 vehicles and to many types of ground babed lighter than gteei, the thickness of the alu- structures. What problems in this area then minum plate can be three tihnes thicker for are peculiar to the design of missiles? The the same weight.
Inasmuch as the buckling answer is that if one again goes back to Atress varies with the square of the thick- considerations of aerodynamic heating and ness, the aluminum plate .Aill have a buckling finds that the thermal inputs are significant, strtss that is approximately nine times that then design criteria established in connection ol the comparable steel plate. This is one with the strength and stiffness requirements of the strong reasons that aluminum alloys mupt be re-examined.
Reference 4 contalps are selected over steels in the design of most a more detailed discussion of the strength, aircraft and missiles that do not operate at stiffness and fatigue requirements for both temperature in excess of say 400CF. cold and elevated temperature structures and if buckling of a structural component re- proposes revised design criteria for struc.- suits in the collapse or.failure of the entire tures at elevated temperatures. structure, it is clear that the buckling stress Briefly, the complicating factor is the de- of the structural component would be the pendence of the design criteria, and even the maximum allowable stress.
In such Ln event, stress analysis itself, on temperature and the structural designer must increase the time parameters. Investigation of the yield cross-sectional area of the componeat until strength of a heated structure may serve as the value of the stiess falls below the maxi- an illustration. At room temperature, the mum allowable. It might be proper to point yield strength of a tructure, in the simplest out, however, that buckling of a structural case, is a matter of keeping the stresses component does not necessarily correspond to below the yield' stress of the material used failure of the entire structure. Consider, for in the construction of the structure.
Room example, a structure composed of a single temperature mechanical data of this sort is bar in compression. The buckling load and abundant and easily available. At elevated maximum load or s11 one-dimensional ele- temperatures, however, the mechanical prop- ment are identical fo- k.': practical purposes, erties of the raterial may undergo significent Buckling wculd correpord to failure o both changes. Inasmuch as these data are also ) the elemert and the structure. This is not available, it would seem logical to use the 69