2 Functions of Devices in DVP-PLC the completion flag will be set after the target number of pulses is reached. Note 2: If DICF in an interrupt is used to change the target frequency, please note that the reaction time of the interrupt will affect the execution of the final output section. 3.
Sample program Setting initial values Setting the target frequency in the final output section Setting the number of pulses in the final output section Setting the acceleration time in the final output section Setting the deceleration time in the final output section Setting the initial target frequency No limit on the number of output pulses Setting the interval frequency between variable speeds Setting the interval time between variable speeds Clearing the number of pulses output by Y0 Actual output control program Enabling the variable speed function of Y0 The number of pulses output by Y0 is 1000. M1 is set.
Enabling the final section output function of Y0 Changing the target frequency of Y0 Setting the number of pulses output by Y0 in the final output section Y0 is in the final section output state. DVP-PLC Application Manual 2-141