DVS-108 Series Managed Industrial Ethernet Switches User Manual 3.2.1.3 Trap Flags After you configure the trap communities, you also need to configure what kinds of SNMP traps the switch can generate and send. When the switch detects the active trap which is an identified condition, a trap will be sent to the trap communities. Trap Flags 3-38 Description Factory Default Protocol Specify the IP version that is used for the trap community: IPv4: Sends traps to an IPv4 address. Input an IPv4 address in the Address field. IPv6: Sends traps to an IPv6 address. Input an IPv6 address in the Address field.
None Address Enter an IPv4 or IPv6 address according to the selection in the Protocol drop-down list. For an IPv6 address, enter the address as xxxx:xxxx:xxxx:xxxxx:xxxx:xxxx:xxxx:xxxx format. None Description Factory Default Authentication Specify whether authentication traps are enabled. Enable: Specify the switch which sends authentication trap messages. Disable: Specify the switch which does not send authentication trap messages. Enable Cold Start Specify whether cold-start traps are enabled. Enable: Specify the switch which sends cold-start trap messages. Disable: Specify the switch which does not send cold-start trap messages.
Enable Warm Start Specify whether warm-start traps are enabled. Enable: Specify the switch which sends warm-start trap messages. Disable: Specify the switch which does not send warm-start trap messages. Enable