EWM1000plus EWM2000evo EWM3000new 2.6 CLUB DISPLAY Version with selector and incorporated ON/OFF switch 2.6.1 Access to diagnostics system 2.6.2 Rapid reading of alarm codes The last alarm code can be displayed even if the programme selector is not in the tenth position (diagnostics) or if the appliance is in normal operating mode (e.g. during the execution of the washing programme): Є Five minutes after the switching on, press and hold down the 8 and 7 buttons simultaneously for 2 seconds, the LCD display shows the last alarm codes (of the main board and display board). The displaying of the alarms depends on the time in which the buttons are hold down.
Є During the time the alarm is displayed, the appliance continues to perform the cycle or, if it is in the selection phase, it keeps in memory the options previously chosen. 2.6.3 Cancelling the last alarm It is good practice to cancel the last alarm, after reading the alarm code to check whether the alarm re- occurs during the diagnostics control after the reparation of the appliance QUICK GUIDE AND APPLIANCES LIST 21/176 599 72 40-80 1. Cancel the set programme and switch the appliance off. 2. Press buttons 8 and 7 simultaneously, then, holding them down, switch the appliance on rotating the programme selector of one position clockwise. 3.
Hold the buttons down up to DIAGNOSTIC MODE appears (about 5 seconds). 4. To exit the diagnostics system switch the appliance off, on and then off again. 1. Select diagnostics mode and turn the programme selector to the tenth position (reading of alarm) 2. Press simultaneously buttons 8 and 7. 3. Hold them down until the alarms are cancelled.