9.9 Drum lifter The drum lifter can be removed from the interior for stainless steel tubs (G10-G11-G12-G13) and the type G17-G18-G19 Carboran tubs. For type G20-G21 Carboran tubs, it is necessary to remove the drum before replacing the lifter. ѓ Removal a. Insert a screwdriver into the following holes: for G13 tubs, into the fourth hole in the lifter for G10-G11-G12-G18-G19 tubs, into the third hole in the lifter for G17 tubs, into the second hole of the lifter b. Bend the drum anchor tabs as shown in the figure (62) c. Pull the drum lifter towards the door of the appliance and detach from the drum (63) ѓ Re-assembly (G10-G11-G12-G18-G19 tubs) a.
Check that the anchor tabs are parallel with the drum band. b. Insert the new lifter into the drum and push towards the rear of the appliance. c. Detach the hose connecting the tub to the filter body d. Tighten the screw through the hole in the tub to secure the lifter to the drum (64) ѓ Re-assembly for G17 tubs (32 cm washing machines) a. Check that the anchor tabs are parallel to the drum band. b. Insert the new lifter into the drum and push towards the rear of the appliance. c. Detach the steam venting hose from the tub. d. Using a screwdriver through the hole in the tub, bend the anchor tabs so that the drum lifter is firmly secured (65). SOI/DT 2002-05 eb 109 599 35 23-17