9.2.3 Timer Version with internal knobs on control panel: a. Remove the work-top. b. Remove the control panel c. If present, remove the screw that secures the knob-spindle (or coupling) and remove the knob. d. Remove the two screws which secure the timer to the cross-member (18). e. Detach the wiring connectors and remove the timer. Version with external knobs on control panel: a. Remove the control panel b. Remove the knob: Ц Release the knob cover by pressing gently in the hole with a small screwdriver and turning the knob cover counter- clockwise (versions 10-11). Ц Insert a screwdriver from the interior of the support cross- member (version 19) and remove the knob c.
Remove the screw which secures the knob-spindle (or coupling) and remove the knob (20) d. Detach the programme flange from the camme (if featured). e. Remove the two screws which secure the timer to the cross- member (18) f. Detach the wiring connectors and extract the timer. 18 10 9.2.4 Water distribution camme a. Remove the control panel and the timer. b. Detach the camme from the cross-member. 19 9.2.5 Detergent dispenser lever mechanism feeler arm a. Remove the camme b. Use a cross-head screwdriver to turn the latch 90°. c. Detach the latch from the cross-member and remove the feeler arm. 20 9.2.6 Push-button a. Remove the control panel b.
Using a screwdriver, widen the pushbutton anchor pin and remove the pushbutton. c. Remove the pushbutton. Using pliers, close the anchor tabs which secure the button to the cross- member and push towards the interior of the appliance. d. Detach the connector 21 9.2.7 Adjustable thermostat a. Remove the knob: Ц Remove the control panel (if internal) Ц Use a screwdriver from inside the support cross-member (if type 19) Ц Release the knob cover by pressing gently in the hole with a small screwdriver and turning the knob cover counter-clockwise (versions 10-11) b. Remove the coupling from the thermostat spindle or remove the knob (22) c. Detach the connectors d.
Detach the thermostat body from the plastic support and remove from the internal side e. Detach the bulb from the tub (see Access to the thermostat: 9.5.3) f. Remove the capillary from the retaining clamps When re-assembling, secure the capillary using the original clamp and loop to form a number of spirals. 22 SOI/DT 2002-05 eb 99 599 35 23-17