Projector Parts - Interface 14 Name Function F SDI Out/In ports (BNC) (EB‑PU2010B/EB‑PU2010W only) Inputs video signals from SDI compatible video equipment. Outputs video signals input from the SDI In port to an external monitor. You can connect two projectors in a chain using a SDI cable. If you want to output images to an external monitor when the projector is turned off, select Always On as the A/V Output setting in the projector's Extended menu. s Extended > A/V Settings > A/V Output G Service port (USB connector Type B) This port is used for batch settings and firmware update.
H USB-A port (USB connector Type A) Use to connect a USB memory device for projecting movies or images in Content Playback mode. Use to connect the optional camera. Provides a connection for a streaming media player to power it. Attention • Use the USB cable supplied with or specified for use with the device. • Do not connect a USB hub or a USB cable longer than 3 meters, or the device may not operate correctly. I HDMI port (HDMI) Inputs video signals from HDMI compatible video equipment and computers. Connects the optional base unit. This port is compatible with HDCP2.3. (Audio is only supported by PCM) Name Function J DVI-D port (DVI-D 24-pin single) Inputs the computer DVI-D signals.
This port is compatible with HDCP1.4. K HDBaseT port (RJ-45) Use to connect a LAN cable to the optional HDBaseT Transmitter. You can use a network cable up to 100 m in length. To ensure proper data transmission, use a Category 5e STP cable or better. However, operation is not guaranteed for all input/output devices and environments. This port is compatible with HDCP2.3. Check the following settings: • To enable communication from the Ethernet and serial ports on the transmitter, select On as the Control Communications setting in the projector's Extended menu.
s Extended > HDBaseT > Control Communications • If you have connected an Extron XTP transmitter or switcher, select On as the Extron XTP setting in the projector's Extended menu. s Extended > HDBaseT > Extron XTP L LAN port (RJ-45) Use to connect a LAN cable to connect to a network. Use a 100Base-TX or 10Base-T network cable. To ensure proper data transmission, use a Category 5 shielded cable or better.