Epson L-4533A/L-4533AW/L-4033A/L-4033AW Maintenance Guide Before Inspections Switching Inspection Mode It might be necessary to switch the inspection mode, depending on the cleaning area. Beginning of Operations, End of Operations A Perform the operation that is displayed on the touch panel, and add a check mark. When it is necessary to switch modes, Switch Mode is displayed. Press this button to proceed to the next operation. B When all necessary operations are completed, Finished is displayed. Press this button to finish. Other than Beginning of Operations, End of Operations A Select Periodic Maintenance in the maintenance menu.
B If it is necessary to switch modes, press Switch Mode and select a mode. C After you have performed the operations, press Finished to finish. When in Shift Carriage mode, follow the on-screen instructions to confirm that the cleaning jig has been removed. The inspection points and modes are shown below. 19 Inspection Points Mode Feeding Unit Motor Drive Off Heater/Rewinder Unit Motor Drive Off Heater Substrate Guide - (Power Off) Platen Unit Motor Drive Off Ink System Shift Carriage Foreign Substance Sensor Shift Carriage Filter Normal Maintenance Tank Normal