Command List of the Alphabetical Order 1 "Priority" indicates the function is executed with priority. ESC/Label Command List Rev. C SHEET22 CW-C4000 series Command Function identifier Command name Description Classification Command code Description of parameters Definition range for ESC/Label Definition range Factory-set initial value Corresponding ZPL II command Priority 1 ^LT Shift vertical position Sets the amount to adjust the position of the label's leading edge. Media configuration ^LTd d: Label leading edge position adjustment [dot] -9999 ≤ d ≤ 9999 -258 ≤ d ≤ 258 ^LT Low ^MC Set drawing deletion after print Sets deletion for the drawing canvas after printing. Format ^MCe e:
Set/cancel drawing canvas deletion e = Y/N Y: Set N: Cancel e = Y/N Y: Set N: Cancel ^MC Low ^MF Set recover operation Sets the operation for when turning the power on and when changing the media. Printer setting ^MFo,s o: Power on operation o = C/F/L/N/S C: Calibration F: Feed L: Measure media length N: No feed S: Short calibration o = C/F/L/N/S C: Calibration F: Feed L: Measure media length N: No feed S: Short calibration ^MF Low s: Media change operation s = C/F/L/N/S C: Calibration F: Feed L: Measure media length N: No feed S: Short calibration s = C/F/L/N/S C: Calibration F: Feed L: Measure media length N: No feed S:
Short calibration ^MM Set print mode Sets the printer operation for when printing is completed. Printer setting ^MMm m: Print mode m = T/P/R/A/C T: No cutting P: Manual peeling and application R: Rewind A: Automatic peeling and application C: Cutting performed m = C/P/R/T C: Cutting performed P: Manual peeling and application R: Rewind T: No cutting ^MM Low ^MN Set label edge detection Sets the label edge detection method. Media configuration ^MNs s: Label edge detection s = N/Y/W/M N: Continuous paper (Does not detect label edge) Y, W: Gap detection M: Black mark detection s = N/Y/W/M N: Continuous paper (Does not detect label edge) Y, W: Gap detection M:
Black mark detection ^MN Low ^MP Enable/disable button Enables/disables buttons. Control panel ^MPo o: Disabled button o = W/F/X/M/S/E W: Disable pause button F: Disable feed button X: Disable cancel button M: Disable menu button S: Disable all buttons E: Enable all buttons o = W/F/X/S/E W: Disable pause button F: Disable feed button X: Disable cancel button S: Disable all buttons E: Enable all buttons ^MP Low ^MU Set units of measurement Sets the unit for specifying the rendering position and size. Printer setting ^MUu,i,o u: Basic printer unit system u = D/I/M D: Dots I: Inches M: Millimeters u = D/I/M D: Dots I: Inches M: Millimeters ^MU Low i:
Rendering resolution [dpi] i = 150/200/300/600 i = 150/200/300/600 o: Print resolution [dpi] o = 200/300/600 o = 200/300/600 200 [dpi] is to be used only when 200 [dpi] was specified for ^S(CLR,Z: print resolution of replaced printer. ^P(M BZ Execute buzzer Eexecutes buzzer. Printer control ^P(MBZ None None None Low