^FT [Name] Field origin location [Format] ^FT x ,y ,j [Function] Sets the field’s rendering origin relative to the home position. Whether the field rendering origin is put in the bottom left or bottom right of the field is set based on Parameter j. When left is selected, the field rendering origin is put in the bottom left of the field. When right is selected, the field rendering origin is put in the bottom right of the field. The y-direction coordinate in the top of the field matches with the top rendered edge. However, if the block height is specified based on “^TB”, the specification of “^TB” is followed.
The x coordinate in the right or left side of the field (side farther from the origin) is determined as follows. If left is selected, the x coordinate in the right side of the field matches the farthest-right rendering edge. However, if the block width is specified based on “^TB”, the specification of “^TB” is followed. If right is selected, the x coordinate in the left side of the field matches the farthest-left rendering edge. However, if the block width is specified based on “^TB”, the specification of “^TB” is followed. The position of the rendering origin for the field on the label is set based on Parameters x and y.
The rendering origin is a relative coordinate from the home position. ESC/Label Command Reference Guide Rev. L Page 119 Parameters Description Definition range x x coordinate of field rendering origin on label [dot] 0 ≤ x ≤ 32000 y y coordinate of field rendering origin on label [dot] 0 ≤ y ≤ 32000 j Rendering origin in the field j = 0/1/2 0: Left 1: Right 2: Auto