System Messages - Alphabetical List *[Fatal] Addr Err* at aaaaaa m:n I=xxxx, A=aaaa, F=ff (None) Explanation: An internal problem has occurred with the eV+ software or with the system hardware. User action: It would be appreciated if you would report the error to Omron Adept Application Engineering. Please include the details of the error message and exactly what you were doing at the time the error occurred. To save programs that are in memory, you can restart eV+ temporarily by pressing Ctrl+G. The robot servos do not function, but you can STORE the programs. Then power down the controller and restart the system. *[Fatal] Bus Err* at aaaaaa m:n I=xxxx, t=aaaa, F=ff (None) Explanation:
A computer error occurred because of a bad read from memory, because of noise on the internal data bus, or because of a hardware problem. User action: To save programs that are in memory, you can restart eV+ temporarily by pressing Ctrl+G. The robot servos do not function, but you can STORE the programs. Then power down the controller and restart the system. If the problem persists, contact Omron Adept Customer Service. *[Fatal] CHK Trap* at aaaaaa m:n (None) Explanation: An internal problem has occurred with the eV+ software or with the system hardware. User action: It would be appreciated if you would report the error to Omron Adept Application Engineering.
Please include the details of the error message and exactly what you were doing at the time the error occurred. To save programs that are in memory, you can restart eV+ temporarily by pressing Ctrl+G. The robot servos do not function, but you can STORE the programs. Then power down the controller and restart the system. *[Fatal] DIV Instr Err* at aaaaaa m:n (None) Explanation: The eV+ system has detected an error from a divide instruction. This indicates a processor fault. User action: Power down the controller and try starting it again. If the problem persists, contact Omron Adept Customer Service. *[Fatal] Emul 1010 Trap* at aaaaaa m:n (None) Explanation:
An internal problem has occurred with the eV+ software or with the system hardware. eV+Language Reference Guide, v2.x, 18319-000 Rev A Page 604