STOREM monitor command STOREM monitor command Syntax STOREM /qualifiers file_spec = module Function Store a specified program module to a disk file. Usage Considerations STOREM can be used while a program is executing. There must be sufficient room on the disk to hold the new disk file. Otherwise, the store operation will fail. Protected and read-only programs in memory cannot be stored. Parameters /qualifiers Any combination of up to three qualifiers may be specified to store multiple data types in addition to the module programs. If all the qualifiers are omitted, only the module programs are stored in the specified file.
If /L is specified, the global location and precision point variables referenced directly by the module programs are stored in a .LOCATIONS section at the end of the file. If /R is specified, the global real and double variables referenced directly by the module programs are stored in .REAL and .DOUBLE sections at the end of the file. If /S is specified, the global string variables referenced directly by the module programs are stored in a .STRINGS section at the end of the file. file_spec Specification of the disk file into which the programs should be stored.
This consists of an optional physical device, an optional disk unit, an optional directory path, a file name, and an optional file extension. The current default device, unit, and directory path are considered as appropriate (see the DEFAULT command). If no filename extension is specified, the extension ".PG" will be appended to the name given (for disk files only). eV+Operating System Reference Guide, 2.x,18321-000 Rev A Page 171