4-8 POWER TAKE-OFFS E UROCARGO Euro 4/5 Power take---off from the transfer box 4.3 Power take-off from the transfer box On vehicles with all-wheel drive (4x4) the application of power take-offs is possible on the transfer box; the number of revs for use can be selected according to the use via the most suitable speed of the gearbox. Use is only with the vehicle stationary (transfer box in neutral). The prescriptions on correct use are given in the vehicle’s Use and Maintenance booklet. There follow the possible measurements: Table 4.2 Type of transfer box Optional PTO Max.
capacity (Nm) Output type Power take-off 4.4 Power take-off from transmission Authorisation to fit a power take-off on the transmission downstream of the gearbox will be issued after examination of the full documentation, which must be presented to IVECO. The various power and torque values will be evaluated as each occasion arises on the basis of the conditions of use. In general the following should be noted: - the drive take-off may be operated only when the vehicle is stationary. - The power take-off r.p.m. is tied to the gear selected. - The power take-off must be located immediately downstream of the gearbox.
For vehicles with the transmission in two or more sec tions, the power take-off may also be applied at the site of the flexible support included between the first and second sections (respect the indications given in point 2.8.8). - The angles of the transmission on the horizontal plane and vertical plane must be kept as close as possible to the original values. - Masses and rigidity added to the transmission must not provoke a loss of balance or abnormal vibrations or damage to the organs of the drive transmission (from engine to axle) either during vehicle movement or during operation with the motor running - The power take-off must be anchored to the chassis with its own suspension.
As the transmission is is an important organ for the safety of the vehicle, modification to it must only be carried out by specialist companies approved by the supplier of the transmission. ! Power take-off from the transfer box Base - January 2008 Print 603.93.431 TC 700 05291 500 ext. diameter flange 90 mm 4 holes diameter 8.1 mm