CHASSIS MODIFICATIONS 2-23 E UROCARGO Euro 4/5 In those cases where the joint between the cross member and the gusset plate is made by means of a weld, it is permissible to join the gusset plate to the reinforcement by welding (see Figure 2.7). When the increase exceeds 350 mm, Figure 2.8 shows the procedure to be used. Figure 2.7 91454 1. Added portion - 2. Reinforcing runner - 3. Reinforcing runner (alternative solution) - 4. Original rear cross member Figure 2.8 91455 1. Added portion - 2. Reinforcing runner - 3. Original rear cross member - 4.
Supplementary cross member (if necessary) So will be necessary to examine on a case by case basis, the feasibility of installing a supplementary cross member to give the frame sufficient torsional rigidity. Adding a supplementary cross member with the same properties as the standard production cross mem- ber is necessary whenever the distance between two cross members is greater than 1200 mm. Modifying the rear overhang Print 603.93.431 Base - January 2008