Required Tools G #2 magnetized Phillips screwdriver (6-inch shaft) G Small flat-blade screwdriver G Small pair needle-nose pliers G T-10, T-15, and T-20 Torx driver (6-inch shaft) All components in the printer, the 2000-sheet Input Tray, 7-bin Tabletop Mailbox, and the 2 x 500-sheet Input Tray use Phillips head screws that require a #2 size Phillips screwdriver. Make sure to use a Phillips screwdriver and not a Posidriv screwdriver. Figure 6-1 shows the difference between a Phillips and a Posidriv screwdriver. Note that the Phillips tip has more beveled surfaces.
All screws used in the field-replaceable units of the 8-bin Mailbox and the 5-bin Mailbox with Stapler components require a T-10, T-15 or T- 20 Torx driver. Figure 6-1 Phillips vs. Posidriv Screwdrivers Note See table 6-1 on page 160 and Chapter 8 for a list of the screws and other common hardware used in the printer. CAUTION To install a self-tapping screw, first turn it counter-clockwise to align it with the existing thread pattern, then carefully turn clockwise to tighten. Do not over-tighten. If a self-tapping screw-hold becomes stripped, repair of the screw-hole or replacement of the affected assembly is required. C4085-91087 Required Tools 151