Back Cover Figure 6-6 Back Cover Note Remove the metal back cover and the plastic panel at the right rear as a single unit. The square opening at the upper rear corner on the right- side plastic panel is the engine test access (callout 6). 1 Remove 5 screws (figure 6-6, callout 1). 2 Open the top cover door, and remove 1 screw (figure 6-6, callout 2) 3 Open the 2000-sheet Input Tray transfer door (if installed), Tray 1, and the Right Lower Door Assembly (callout 7). 4 Remove 2 screws (figure 6-6, callout 3) from the plastic panel to the left of the metal back cover.
5 Carefully release the cover around the AC input connector (figure 6-6, callout 4) at the lower right of the back cover, and slide the right side of the cover slightly forward. 6 Carefully release the retaining tabs (figure 6-6, callout 5) on the plastic panel to the left of the metal back cover by gently pulling the cover to the left while moving both pieces away from the printer chassis. C4085-91087 Engine Removal and Replacement 167